I blew up the rear rotor in a turbo car.  I was able to keep

the engine running on one rotor (I knew if I let it die it would
not restart).  I drove it that way 30 miles, it got me home.
Of course not at full power.

--
Perry Mick
Duckt N7XR
http://www.ductedfan.com

Was it ignition failure that caused this Perry? Did you take
that engine apart? Were the rotor or stator gears failed? Hard to imagine the engine
still running with blown phasing gears.

Paul Lamar

The engine will run with no teeth left in the rotor. The housing will be guiding the rotor around and since it is no longer being timed it will be sliding along on the housing. The apex seals will stick in the grooves instantly and the rotor will produce no more power. You can do a lap at Pocono like that (with about 25 HP)but all you can salvage will be the distributor and the oil pan. Every thing else will be well done and extra crunchy.
Lynn E. Hanover

Lynn let me get something else straight. 
What you are talking about in reference
to  cross fire is for the 12A distributor engines where the mag pick up modules are
mounted on the side of the distributor. These control two separate coils. The high voltage
from the coils  is then switched around to the various spark plugs as needed by 
the ignition rotor and the distributor cap. Is that correct? In that case you 
have the high voltage from the two simple coils and the low level signals from 
the mag pickups and amps in the same metal can. I.E. the distributor body.

I can see how that was not smart on Mazda's part. The later 87-92 13B crank
angle sensors did not have that problem as the crank angle sensor only sent a 
low level signal pulse to the computer and the computer fired the amplifiers
built into the base of the two coils. Right? or are they affected too?
One amplifier/coil for the leading plugs and one amplifier/coil for 
the trailing plugs.

I am not familiar with the amplifiers and  coils on the 1993 and later engines
but the crank angle sensor is on the nose of the e shaft and is no longer
a device driven with a bevel gear and shaft. 

The MSD set up on the other hand uses a separate low level trigger from some 
place and a separate amplifier box and a separate coil. Correct?
Racing beat uses one completely separate MSD system and coil for each spark plug
on their 900 HP turbo three rotor.

Also what Tracy is doing is using one GM/Nippon Denso amplifier/coil per 
spark plug and sending low level pulses from the computer to fire each one
individually. Is that correct Tracy?


Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org