Here is the information on my 88 engine (turbo 13b), original intake
manifold.  Notice that the equivalent area is over three inches dia.

Rino

Good work Rino. Thanks for working this out. Next time this subject
comes up we will hit them with this.

Perfectly CLEAR! Thanks guys. So what you are saying is short

of making one, everything out there is going to be small?

...Chrissi

Chrissi,
You do it deliberately. I know you do.
Good luck getting a big enough throttle body. I hate to admit it now, but I
need one too. Let me know what you decide on.
John Slade

Hi Paul,

Since your are using my drawing I sent you a cleaner one the 23" runners
info and the Ford throttle body is on my installation.  Notice that my
throttle body area (Ford throttle body) is smaller than the total area
of the intake manifold runners.  I will still try this setup, it might
give me the power that I am looking for (200 HP max.)

Rino

Thanks again Rino.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org