Subject: how to cool a 1 1/2 " diameter by 12 " hardened steel shaft
From: ACRE NL
Date: 2/1/2002, 8:53 AM

Russell Kent wrote:

Search your local grocery stores; some of ours carry dry ice.  Freeze the shaft the night before, then go to the store to get a throw away styrene ice chest, a gallon of rubbing alcohol (70% stength or better), and 5-10 lbs of dry ice. Put
the alcohol in the chest, break up the dry ice into the chest, and put the shaft in the alcohol.  Leave it for an hour or so (make certain the area is well vented: CO2 will suffocate, and the alcohol fumes are flammable).  It should get
the shaft down to about -60 C.  We used to use this technique in the lab (using 99% ethanol :-) to freeze-dry samples.

Russell Kent

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org