Subject: oil O-rings sizes
From: ACRE NL
Date: 2/3/2002, 11:42 PM

Old message from the CD.
I will get the water O-rings sizes shortly.

To be on the safe side measure the slots
and order from Creavey by sizes and not part numbers.
The basic thing is you want an O-ring that is
only 10 to 15% larger in dia then the DEPTH of the 
slot. The slot width in general should be much
wider than the depth giving room for the O-ring to
expand in volume.

Paul Lamar


Subject:        Oil O rings. proper sizes.
   Date:       The, 07 Jun 2001 12:23:44 -0700
  From:        ACRE NL <rotaryeng@earthlink.net>
    CC:        Mazdatrix <mail@mazdatrix.com>

I checked the installation of the oil O-rings with the new
sizes I got from Creavey. They worked perfectly and were
very easy to install. You will need a little O-ring lube
and a 2 by 8 to install them. They were also easy to remove
with no signs of distortion.

One of the secrets is if you reuse the old oil scraper rings
they must be spotlessly clean inside and out. Soak them
in carb cleaner for a few days. If you use new scraper rings
this will not be a problem of course.
The second thing to watch out for is don't nick the 
rotor wall between the two scraper rings when you remove them.
Very very important!!

Hopefully we can talk Dave Lemon into stocking these custom size
teflon encap silicon oil O-rings. Everybody send a message to 
Dave at Mazdatrix :-) As I said these can be the same or just a 
little more than the stock oil O-rings from Mazda.

The proper sizes are:

0.093" section 4.68 inch ID 
0.118" section 4.33 inch ID 

I can vouch for the quality of the Creavey O-rings but some 
of those water TES o-rings from Mcmaster Carr I have seen 
are not as good. This is not to say they won't work. They just 
don't look as good around the joints as Creavey O-rings.
 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org