No not yet. My rotor housings have a small groove I don't
like, see attached
photo. I am waiting to see if Mike Harrington has any
better ones he
will
sell. The oil consumption on my current motor seems to
have leveled off
at 1
qt per 3 hours so the need is not urgent yet. Maybe
another month or so.
BTW I reused most of the seals (apex, corner, and steel
oil seals) when
I
rebuilt the current motor. The new motor will have all
new seals. Hurley
apex seals, stock Mazda gasket set and housing O-rings,
your TES oil
seal O
rings.
Chuck Dunlap
I dug out a few housings this weekend, do you need T2 or
NA? I think the 2 I
saw were 86-88 NA housings. Need to clean them up a bit to
check the chrome
and I didn't have a lot of time this weekend. Will keep in touch.
Mike
I need (2) 1986 NA housings, I like quiet exhaust! I hope you find them, I
really do not want to run my new apex seals over the groove in my housing.
Thanks Mike.
Chuck Dunlap
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org