Subject: Ball bearing slide throttle.
From: ACRE NL
Date: 2/4/2002, 3:11 PM


more importantly, when the slide is closed... what is covering the pipe?
...Chrissi

Sorry about that!
This should work a lot better.

It would cover the pipe the other way Chrissis. The slide was solid.
This drawing is a bit clearer. I liked the other one better as it was shorter.
This one on the other hand will give you a perfectly streamlined
system with WOT. The ball stops are now shown.


Sorry, it is the most common error in laying out this type of mechansim; first thing I look for.
I would also remove 25% of the balls, add some clearance and put in a perforated flat strip in between as a bearing cage, balls will behave better and not scrub against each other.
...Chrissi


I think that is a good idea. A real improvemnt. Perhaps teflon.
Paul Lamar

  If you look closely that bearing retainer is already there.

By God you are right Erwin. I see it now.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Hoernemann-THROTTLEBODY4.GIF