I'll bet that this has been tried before (hard to come up
with truly original ideas), but has anyone heard of using a
'plug' in the end of the intake bellmouth as a throttle?
What I'm seeing is something shaped like an oven baster,
with the pointy end into the bellmouth. If it has an inside
radius which follows the bellmouth shape of the intake,
couldn't you have throttle action without the turbulence of
a butterfly valve (or slide at part-throttle)? I can see a
few design issues, like complexity, having enough force
available to overcome the vacuum as you try to 'open' the
throttle, & designing for 'fail open' instead of 'fail
closed,' but for the moment I'm just interested in the air
flow issue. I'm also assuming that throttle response & idle
characteristics won't be problems due to using electronic
injection.

Somebody shoot this full of holes. I can take it.

Charlie England

I can see it working in several areas. There are two problems that

might be helped with this lashup. One would be the limit space above
an air horn inside an air cleaner housing. If the bell shaped horn
it too close to a flat surface, say less than one diameter of the
intake runner, then when the cylinder pulls on that runner a lot of
energy is installed by spinning the inlet air. This tends to choke
off the inlet and make it flow as though it is smaller in diameter.
When measuring velocities away from the walls of the inlet, I find
that the very best flow is straight down the center of the inlet. I
think, and may be able to prove that such a device might improve
flow when fixed on the cover of a filter housing across from each
inlet horn. This same shape then could be forced into the horn by a
tiny hydraulic cylinder connected to the throttle with a stiff
spring inside the cylinder to drive it open. Where along the bell it
touches (what diameter) determines the loading. Or, if you

take that another step, make the horn and a bit of the runner

slide up against the cover, to close the throttle. I suspect that in
many applications there should be a set of thin sheet blades inside
the inlet horn to prevent this unwanted rotation. Another job for
Mr. flow bench.

Lynn E. Hanover

        Hey, the turkey baster has a hole in the center.
Set the hole size for idle when the bell is closed. As
a trumpet mute with an opening in the center, Virg

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org