Rick Girard wrote:

I'm in the throws of designing an engine mount for the 13B
in my Long EZ.  Does anyone have, or know the whereabouts on
the web of a drawing of the engine in dwg or dxf format.  I
have the gif drawings that Ed Anderson was kind enough to
post, but I'm thinking more on the line of a drawing with
all points referenced off the E shaft center line.  My
engine is still being built up at Hayes so I can't do this
on my surface table at home.  If I had all my wishes the
engine would have a 12A front cover. If the other reference
surface was either the bell housing mating surface or the
front cover mating surface I could just measure the 12A
front cover and add it in.

Thanks to all,
Rick Girard
13B + LEZ

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org