Paul - When you were doing your pressure measurementa with the RX 7
did you consider mounting your muffin fan anemometer just behind the
radiator in a stategic location to rough check thru velo? would be
interesting.
While in the data collecting mode it would be neat to have a flowmeter
in the coolant flow, and in and out temps - might be doable and interesting
I might be interested in building a turbine flowmeter - some one else to
do the electrics for a counter ??
- Vance Jaqua
Sounds like a good idea. Actually a lot of low cost hand held VOMs now a days
have built in counters.
Here is what the end of the manometer tubes look like. This is a piece of ordinary
porous kitchen sponge. Comes in red, green, blue, yellow and pink.
What this does is makes sure you are measuring static pressure and not
the dynamic pressure from some local air currents.
It is fastened to the end of the black vinyl drip irrigation tubing with hot glue.
$4 bucks for 50 feet. The same sort of static pressure tap is used
everywhere else unless you want to measure dynamic pressure.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org