Racing Beat mentioned something about needing special tools and their
being
hard to come by. In particular, they mentioned an "E-shaft splitter". <
Don't sweat the E-shaft splitter. You can make one with a 18 inch length of
3/4 inch allthread, with a 12 mm thread on one end(same thread as the o2
sensor), a heavy piece of metal with a 1 (+_) hole in it about a foot long
and a pad (Al?) to protect the end of the E-shaft. Not quite the $900 I was
told it took for Mazda's special tool and it worked fine.
Bob Darrah
(512) 264-1717
A sketch or picture would be nice Bob. Mail me something if you don't have a scanner.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org