Subject: Mystery EFIS & fire warning
From: ACRE NL
Date: 2/7/2002, 11:50 AM


flyboy wrote:

This subject is a big worry of mine since I drive a
pusher I can't see a engine compartment fire until
it's well out of hand. You tractor drivers don't have
this problem. So I'd like to install a high temp/fire
warning system.

I don't want the subject to change from the EFIS some
bright minds are coming up with good solutions and I
do believe someone will hit the target.

I was wondering if someone can point me to a cheap
source for engine compartment high heat switches or
buttons. I'd like to wire a high temp/fire alarm
circuit in my varieze to a simple LCD bulb or
horn+bulb. I've checked with 3 of the big button
makers and they only offer sensors up to about 350
degrees F. tops, and they don't like to sell direct.
I'd like to have 8 or more sensors in and around the
engine, fire wall and spar area that would close the
circuit at around 400, 450, 475 or even 500 F would
do.

This could also be one of the channels the EFIS scans.

New or used Auto/motorcycle ignition points would make
good cheap, reliable switches with a suitable material
that melts at around 450 holding the points open but
that borders on redneck. (((GRINS))) I'd just like to
get a discussion going on this subject.

John

Awhile ago there was some extensive discussions on the Canard Aviators list about this issue. It seemed the concensus was to use a length of twisted pair of solid core wires with cheap vinyl insulation (Radio Hack) and position these in the appropriate parts of the cowling. Not sure what temp the vinyl melts at.
...Chrissi

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org