Subject: 20B overhaul instructions / tools
From: ACRE NL
Date: 2/8/2002, 7:15 AM


Tom Kendall wrote:

<Snip!>

Not to worry too much Bruce Turrentine tells me the 20B overhaul video is
almost soup.
Yes indeed the 20B e-shaft is two pieces.
Here is a picture.

Paul Lamar

Tom Kendall replies:

Cool Beans Paul!  I wondered how they managed to get that middle rotor on
the e-shaft.  Makes sense now.  Using this approach you could (in theory)
make an engine with any number of rotor you wanted.

And Thanks to Bob Darrah for the description of a home-made splitter and how
to use it.  I just have to make sure I keep them filed away and not deleted
until I need 'em!

Here is a drawing of a four rotor using the same e-shaft trick on both ends.

Paul Lamar


Paul,

With "a four rotor using the same e-shaft trick on both ends"  ... are you
suggesting that a 4 rotor could be assembled from existing, readily available
parts?  I thought the (decade old) Le Mans motor was just a "few off" the assembly
line at that time ... three plugs per rotor housing, special coatings, etc.

Is there one "critical part" that would prevent one from doing so?

Would coolant flow be a problem?   Isn't that kinda the achilles heel of the 3
rotor?

If I recall correctly from a previous discussion of balance, the 4 rotor is in
perfect balance and uses no counter weights.  Isn't Bruce Turrentine working on 4
rotor engines?  ... how about an update?

Dale Smith

I am not sure about this. Perhaps if the unique three rotor intermediate housing
is symmetrical but as I recall it is not. The answer is no. A four rotor
cannot be made this way. Two 13B's have been put together however
with a different shaft coupling technique.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org