finally!

Someone else understands how nice solids are!

Attached is a .dxf file of a

13b turbo block. It is close enough for rough

work. I didn't use a cmm or

digitizer, just graph paper, trace, and enter,

so it's not dead nuts, but it

is pretty close. The .dxf file will be 3D

wireframe only. I exported for

AutoCAD 12, if you have a newer version let me

know and I will export a

better solid or suface model. I have been too

busy to add all the bolt

holes, front cover, turbo etc. Hope somebody can

get some use out of it.

Monty

Monty, great stuff! Looks as if you have put a lot

of time into this.

What would the tolerance be approximatly? +/-

.xxx?

...Chrissi

OK Chrissi since you now how to convert it to a 3D
drawing please
plot it to a gif file on hard disk from ACAD and
attach it to a message
for us so we all can see it.

Paul Lamar

Paul,

After Acad12 is open, you open Monty-mazda_13b.dxf.
After you go to the View button on the toolbars...go
down until you reach the 3d views button and down
there hit the SW isometric button. Voilà.

Is simple as that.

Daniel G.

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org