"Harley, Ageless Wings" wrote:

Mornin, Paul...

I also have an EPROM programmer and I might burn a few EPROM'S for

people.<<

I rescued one from my company when I retired back in 1994.  If it gets to be
too much of a job for you, with all the time you spend on this newsletter as
it is, I could probably load up the program in one of my old computers and
do a few, too.

Haven't tried it yet with some of these new fangled machines, but I still
have the old IBM XT computer (that I also "rescued" when I left) that the
program used to run on and may still be on! It might even be fun
resurrecting my "Old" office!

What chips are you considering using?

Harley

Modern Flash technology has reduced the need for EPROM burners.
I was thinking if Finn wanted to upload his old 80C35 design and
somebody wanted to build it as is they would need an EPROM.
On the other hand if they just used his hardware schematic and went with a
Flash PIC there would be no need.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org