Subject: Pressure measurements revisited
From: ACRE NL
Date: 2/12/2002, 8:46 AM

Al Gietzen wrote:

A water manometer can be used to measure air velocities too.
This thing is called a velocity rake. It is used to measure the
thickness of the boundary layer. Very handy if you are doing a
P51 type scoop at the back of your canard. If the boundary bleed is
too high it is too much drag if too low the scoop won't work as well
as it should. If in doubt about the boundary layer thickness this
is the tool to use. Note this is on the middle of the hood of
a first gen RX7 so the boundary layer is very thin. All the readings
are pretty much the same given that there are slightly different
amounts of water in each U tube. Note the red food dye in the
water so it can be photographed and seen easier. Also the first
one on the right is the pressure tap in front of the rad.

FWIW - - I have a little program that computes the turbulent boundary layer
thickness as a funtion of speed and distance from the front of the surface.
(in fact I attached it to an e-mail once, and you didn't pass it along
because it is an executable file).  It says the BL at 3 ft from the front of
your hood at 60 kts would be about 0.6".  What is the spacing of the tubes?

If anybody wants the program, I can send it direct.  Alventures@msn.com.  It
tells me that the boundary layer at the back of my Velocity where my scoop
is is about 1.7 inches at 160 kts.  I'm not sure how it defines the
thickness since there is some sort of hyperbolic velocity gradient.  And of
course you can beak up the layer with a couple of strategically placed vg's

Also, I have found that water in tubes less than about 3/8" have hysteresis
due the surface tension.  This might result in some error in your readings.

Al  Gietzen

The spacing on my tubes was about 1/2 inch.

I also think the boundary layer will be thinner in a high pressure area
such as in the canard main wing armpit area. Particularly at high angles 
of attack. I suspect that program assumes a parallel air flow on
a flat plate. I could be wrong and it could have some sort of curvature
input. Intuitively the angle at which the air strikes the surface has some
affect on the boundary layer thickness.

I agree on the surface tension but I don't think it adds much error
when we are dealing with numbers well over one inch of water.
I can see major differences by driving up behind a truck for example.
The tubes I used are about a 1/4 inch ID. BTW Al do you know if a bit of
house hold detergent reduces the surface tension?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org