Subject: Starting over after kissing a $900.00 deposit good by.
From: ACRE NL
Date: 2/13/2002, 12:18 PM

Jerry Hey wrote:

On Tuesday, February 12, 2002, at 08:09 PM, ACRE NL wrote:

Jerry Hey wrote:

Hi Paul,    It has been some time since I wrote to the newsletter.
However, I have been reading every word and considering how to proceed
from this point.  The thing that has  happened is that the shop that
was
building my chain drive has failed to deliver even though to this
minute
(nine months late!) he is  still making promises to deliver soon.    I
can no longer believe him  or waste my precious time on a design  path
that is never going to happen.   The chain drive had a 5.5 offset from
the eccentric center to the prop center.   I had built the engine mount
accordingly so I am back to square one.  First I am going to either
modify the present mount or build a new one from scatch based on
Tracy's
drive.

The new engine position will be at least 2 inches higher and my present
intake plenum will be too high to clear the cowl.   The engine is a
1986
to 1988 13B six port.   I would like to hear anyones recommendations
for the intake.  I am assuming that the new intake manifold cannot be
used on the six port.

I would like to develop a fire wall forward package just for the
Tailwind.    The N/A 13-B developing 170 hp is PERFECT for the
Tailwind.  If this kind of power is  available without  special engine
prep such as street or Peripheral Porting  that makes the engine all
the
more desirable to the average TW owner.

By the way,  my cooling package now consists of two 275 cu in rads in
the fuselage each with its own intake and separate plenum.  The inlets
will be adjustable cowl flaps.  The fans are no longer in the
design.     Jerry

The new intake manifold is designed to have enough meat around
it so it can be ported with a die grinder to fit the six port
or the 1993  and later larger four ports. 170 HP should be no problem.

The manifold is designed to keep the intakes pipes right down
on the top of the the rotor  housings for minimum package height.

A firewall forward package sounds great Jerry. I am very happy to hear
that. We need more people to do that for specific airplanes.
Send me a drawing of the T.W. hard points on the firewall and the
position
of the thrust line and I will draw up a suggested motor mount.

I will also need the length of the cowl from fire wall to prop flange
position. Best to try and fit it into the stock cowl to minimize your
initial investment.

Paul Lamar

Thanks Paul,  that is a very generous offer.  The Tailwind firewall
forward package is very similar to the RV-6 both for conventional and
tri gear.  If you have already developed drawings for the RV-6 engine
mounts they will work with minor adjustment of the hard points which I
can do .     Attached is Jpeg of the Tailwind gear mount.   Jerry


Looky there. Looks just like an RV4 or RV6. Looks like Van copied
Steve Wittman. OK Jerry I am leaving for a busman's holiday down 
in Florida early tomorrow morning. I will visit Tracy and 
Dave Garber if possible. I will work on it when I come
back.

Hold those email messages folks. The newsletter will be shut down
for a few days. I don't want to freak out earthlink.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Jerry-Hey-Gear_Mt_.JPG