Hi Paul and Group,
Some time back there was some 13B sump details posted, is there any Autocad dwgs avaliable.
I am looking to make the sump amd engine mount in one.
Regards Don Dunbar.
Mustang 11 builder.

I have them in ACAD R12 Don.
Here it is. I used a stock pan to make a pattern to drill the
pan bolt holes. The two ears on the left of the picture are
the rear motor mount brackets. Bruce Frank did a great job of
welding this up for me.

Paul Lamar

Just the drawing I have been looking for. Can I assume this will fit a GEN 3 also?
...Chrissi

Sure. The hole pattern  might be slightly different but you would use
a third gen pan as a pattern to drill the holes any way.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org