Just the drawing I have been looking for. Can I assume this will fit a GEN 3 also?
...Chrissi

Sure. The hole pattern  might be slightly different but you would use
a third gen pan as a pattern to drill the holes any way.

Paul Lamar

Well, maybe yes and no. We have something of a hybrid motor here. The important parts are all new GEN 3 turbo, the front cover is GEN 1 (for mounts and mechanical metering pump), the oil pan is GEN 2 (84 GLE-SE) (compact size), GEN 2 crank angle sensor.
I know the pan we have covers up the GEN 3 motor mounting holes on the rear of the block.
I was just going to remove the pan, tape a piece of paper to the bottom of the block, rub with pencil and digitize the results. If this has already been done then it saves me some work.
Also I noticed that there are different HKS manifold castings for the turbo; what is different about the 13BREW?
...Chrissi

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org