Subject: Aerodynamic Cooling Test - Cowl pressure
From: ACRE NL
Date: 2/21/2002, 8:03 PM


 Paul, Tracy and Group,
 The cowl pressure could
probably be lowered by a vent / louver on the top-front of the cowl
right behind the spinner.  The pressure graphs that I have seen of
the RV-6 show that the area of the prop spinner and the very front
of the cowl as low pressure areas - this probably isn't always true
but would seem to be on Tracy's airplane.  I think that this is why
the cowl pressure (inside the cowl) rose when the cowl opening
behind the spinner was closed - this low pressure area was no longer
used to evacuate the air inside the cowl.  A side benefit would be
the hot air inside of the cowl would have an exit vent (especially
on tail draggers) after the flight was complete.  This would help
cool down the inside of the cowl after shutdown.

Ken Powell

Guys I think just about everybody is missing the point of a cowl flap.
A cowl flap is a variable nozzle device. You DON'T WANT a lot of
opening at high speeds. You WANT TO SQUIRT that hot air out the back
at high speeds just like a jet engine. At climb speeds MOST of the
drag is coming from lift and the fact you are raising a heavy weight.
The airplane and everything in it.  The aero drag of a large flap
opening under those circumstance is of minimal importance yet the
demand on the cooling system is a maximum. You then WANT a large
opening. No fixed orifice of any kind is going to fit the bill.

Paul Lamar


Paul,
Yes, I understand and agree with the need for cowl flaps.  I was offering an
alternative theory on why sealing the cowling with a bulkhead behind the spinner
raised the pressure inside the cowl.

Ken Powell

Ok I apologize. I see your point. That is a possibility. My inclination is to seal
it there as any outward flow of air could cause a bit more drag down stream.
In fact Tracy got the impression the RV4 had a little less drag
after we taped it up but we could not confirm that with a top speed run
as the velocity rake and pressure tubes were duct taped under the right
wing.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org