Subject: Canard cooling air intake
From: ACRE NL
Date: 2/22/2002, 7:59 AM

snips...

Adjustable cowl flaps are called for as the dynamic pressure is four
times higher at 200 MPH than it is at 100 MPH. 100 MPH is
the critical
design point as that is closer to the speed people takeoff
and climb out at.

An air cooled engine I suspect has a lower pressure loss
across it than a rad
and that is why NACA said NACA scoops are not suitable for rads and
oil coolers. I just down loaded that pertinent  12 meg PDF
file from:
http://naca.larc.nasa.gov/reports/1945/naca-acr-5i20/

Paul Lamar


Chrissi:

You might want to look at early Long-EZs that had the P-51 type scoop.
The big belly NACA wasn't even a Rutan original.  Someone
else did that
later and it was widely copied.  Puffer incorporated it into
the Cozy IV
plans.  The bottom of the Long-EZ fuselage starts curving
upward as you
move back toward the firewall, and the NACA that made the bottom flat
to the firewall was just an aftermarket add-on. So you could
reshape the
bottom of the Cozy IV to follow the "ceiling" of the NACA duct.

--
Perry Mick
Duckt N7XR
http://www.ductedfan.com


If you want a bit of evidence that canard people are giving up
on it Dick Rutan
has a set of water cooled cylinders for his Long Ez engine. He is using
the P51 style duct to feed air to the rad. If you do try the NACA
duct please down load the pdf file because some of the design
features are critical
as to how well it works.

http://naca.larc.nasa.gov/reports/1945/naca-acr-5i20/

I also know Klause used a boat tail to get the bottom flat for the NACA
duct on his Variez. A boat tail I suspect will also work to reduce
the drag of the P51 style scoop.

Paul Lamar


Here is an idea for you. Add a little boat tail rudder area and reduce the
drag by recovering some of the cooling energy.

Paul Lamar


Interesting, Paul. That's a lot like what I did, except that I've still got
the plans NACA. I worked a cowl flap in behind the rad.
See http://kgarden.com/cozy/cz535.jpg and
http://kgarden.com/cozy/cz523.jpg

This is just a guess right now. I hope it works!
Regards,
john Slade
Cozy IV

It might. If you can get the pressure down to ambient or below behind the rad
you might get enough airflow into the NACA duct and it might cool OK.
It will be hard to say for sure until you fly it and take a few
pressure measurements.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org