Perry Mick wrote:

Paul:

Paul Conner of Mobile, Alabama is on your list, installing a
13B with Ross redrive in a SQ2000 Canard Pusher.  His
firewall is already set up for the rubber in the firewall mount.
He asked me to design a mount.  I drew this by modifying
my LEZ version.  The engine moved rearward about 3 inches
as compared to mine, to get the prop flange in about the right
place.

Can you do a sanity check on it?  It doesn't show the Ross
redrive, and the actual prop hub location would be about 2.5
inches farther aft than this drawing shows. (The distance from
rear of engine to my prop hub is 12 inches and with the Ross
it is 14.5 inches).

I don't think he will have the same water pump clearance problems
on the right side that I had with the LEZ mount since the mouting
points in the firewall are so much wider.  The drawing still shows
the LEZ firewall, because I didn't have a picture of his firewall,
only dimensions for the mouting points.

Is there someone in the Mobile Alabama area that can weld this up
for Paul?
--
Perry Mick
Duckt N7XR
http://www.ductedfan.com

Looks good Perry. Has all the required tubes.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org