Paul, Tracy and Group,
The cowl pressure could
probably be lowered by a vent / louver on the top-front of the
cowl right behind the spinner. The pressure graphs that I have
seen of the RV-6 show that the area of the prop spinner and the
very front of the cowl as low pressure areas - this probably
isn't always true but would seem to be on Tracy's airplane. I
think that this is why the cowl pressure (inside the cowl) rose
when the cowl opening behind the spinner was closed - this low
pressure area was no longer used to evacuate the air inside the
cowl. A side benefit would be the hot air inside of the cowl
would have an exit vent (especially on tail draggers) after the
flight was complete. This would help cool down the inside of
the cowl after shutdown.
Ken Powell
Guys I think just about everybody is missing the point of a cowl
flap. A cowl flap is a variable nozzle device. You DON'T WANT a
lot of opening at high speeds. You WANT TO SQUIRT that hot air out
the back at high speeds just like a jet engine. At climb speeds
MOST of the drag is coming from lift and the fact you are raising
a heavy weight. The airplane and everything in it. The aero drag
of a large flap opening under those circumstance is of minimal
importance yet the demand on the cooling system is a maximum. You
then WANT a large opening. No fixed orifice of any kind is going
to fit the bill.
Paul Lamar
Paul,
Yes, I understand and agree with the need for cowl flaps. I was
offering an alternative theory on why sealing the cowling with a
bulkhead behind the spinner raised the pressure inside the cowl.
Ken Powell
Ok I apologize. I see your point. That is a possibility. My
inclination is to seal it there as any outward flow of air could cause
a bit more drag down stream. In fact Tracy got the impression the RV4
had a little less drag after we taped it up but we could not confirm
that with a top speed run as the velocity rake and pressure tubes were
duct taped under the right wing.
Paul Lamar
OK, I knew that there had to be a reason that we never see this exploited. Thanks
for the explanation of an increase in drag if this area is 'open'. I can see where slow
moving air from the inside of the cowl exiting directly into the fast moving air right
behind the spinner would cause a lot of drag.
Ken Powell
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org