Paul, Tracy and Group,
The cowl pressure could probably be lowered by a vent / louver on the
top-front of the cowl right behind the spinner. The pressure graphs
that I have seen of the RV-6 show that the area of the prop spinner and
the very front of the cowl as low pressure areas - this probably isn't
always true but would seem to be on Tracy's airplane. I think that this
is why the cowl pressure (inside the cowl) rose when the cowl opening
behind the spinner was closed - this low pressure area was no longer
used to evacuate the air inside the cowl. A side benefit would be the
hot air inside of the cowl would have an exit vent (especially on tail
draggers) after the flight was complete. This would help cool down the
inside of the cowl after shutdown.
Ken Powell
Guys I think just about everybody is missing the point of a cowl flap.
A cowl flap is a variable nozzle device. You DON'T WANT a lot of opening
at high speeds. You WANT TO SQUIRT that hot air out the back at high
speeds
just like a jet engine. At climb speeds MOST of the drag is coming from
lift
and the fact you are raising a heavy weight. The airplane and everything
in it. The aero drag of a large flap opening under those circumstance is
of
minimal importance yet the demand on the cooling system is a maximum. You
then
WANT a large opening. No fixed orifice of any kind is going to fit the
bill.
Paul Lamar
You're definitely right about that. But variable inlets or outlets are a
complication, particularly for me with the engine "way back there"
(Velocity). I do expect that after I'm flying; know exactly what the
conditions are; and have some time; I'll look at variable outlets and/or
inlets again.
Al Gietzen
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org