Interesting, Paul. That's a lot like what I did, except that I've still got
the plans NACA. I worked a cowl flap in behind the rad.
See http://kgarden.com/cozy/cz535.jpg and
http://kgarden.com/cozy/cz523.jpg
This is just a guess right now. I hope it works!
Regards,
john Slade
Cozy IV
It might. If you can get the pressure down to ambient or below behind the rad
you might get enough airflow into the NACA duct and it might cool OK.
It will be hard to say for sure until you fly it and take a few
pressure measurements.
This is what I had hoped to do also except to have the front edge of the NACA moveable so that when I needed it I could drop it down and get a lot more air. This has already been proven to a limited extent by Vance Atkinson on his Cozy. He put a small linear actuator on the leading edge of his NACA and saw a noticable difference in cooling. Once the engine had cooled and stabilized after a climb he retrims it to the normal position. This way you don't have to stair step in a climb the way Tracy does. I will have to see if Vance has any hard data. In his configuration it has +/- 1" of travel, I am talking about dropping it down a whopping 3" with side seals to prevent loss of air. At that point it is no longer a NACA but a scoop. I am just waiting for John to fly his Cozy to confirm whether there is enough cooling in his design once he gets to altitude and things stabilize after climb.
...Chrissi
I assume Vanced Atkinson has an air cooled air craft engine with less pressure
drop or resistance to air flow than a radiator.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org