Subject: Custom 20 B oil cooler
From: ACRE NL
Date: 2/23/2002, 8:38 AM

Al Gietzen wrote:

Here are some pics of the custom oil cooler for my 20B built by Griffin.  It
is a very nice piece of work, and very heavy duty (also heavy, 10 lbs) -
designed for 125 psi operating pressure.  The core is 20.5" long, 5" wide
and 3.34" thick.  Internal turbulators in the wide tubes also hold them
together; they are brazed in.  14 fins/in.  Design point is 1600 cfm air, 16
gpm oil, 220F oil in, 90F air in, resulting in heat rejection of 2330
Btu/min.  Good for 220hp continuous on a hot day.

Griffin says 1.5" water air side pressure drop, 21 psi oil side drop at the
design point.

The quality of the cooler, and of the custom radiator I also got from
Griffin, is, IMHO, excellent.  On the other hand, the custom radiator from
Ron Davis is good, but not great.  It is slightly warped, and, for whatever
reason, the fins are removed for about 3/8" from the tube sheet (tank) at
each end.  In the flow tests I found the air bypassing there was equivalent
to about a 2" length of the core.  I called and asked about it and was told
they just do that to make it easier to braze.  They told me that if I was
concerned about, "just put a bead of silicon to across to block the flow".
Fine; now the length of the core is 15 ¼ instead of 16.  It's funny that
Griffin does need to remove all those fins to make the braze.

The oil cooler also makes a very nice sculpture :-).

Al  Gietzen

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Al-Gietzen-oil_cooler_core.JPG

Al-Gietzen-oil_cooler_scupture.JPG