Subject: Canard cooling air intake]
From: ACRE NL
Date: 2/24/2002, 12:45 AM


This is what I had hoped to do also except to have the
front edge of the NACA moveable so that when I needed it I could
drop it down and get a lot more air. This has already been proven
to a limited extent by Vance Atkinson on his Cozy. He put a small
linear actuator on the leading edge of his NACA and saw a
noticable difference in cooling. Once the engine had cooled and
stabilized after a climb he retrims it to the normal position.
This way you don't have to stair step in a climb the way Tracy
does. I will have to see if Vance has any hard data. In his
configuration it has +/- 1" of travel, I am talking about
dropping it down a whopping 3" with side seals to prevent loss of
air. At that point it is no longer a NACA but a scoop. I am just
waiting for John to fly his Cozy to confirm whether there is
enough cooling in his design once he gets to altitude and things
stabilize after climb.
...Chrissi

I assume Vance Atkinson has an air cooled air craft engine
with less pressure
drop or resistance to air flow than a radiator.

Paul Lamar


Yes, he has a Lycoming. You might take a look at the airpath of
a plans built Cozy. Not what I would call freeflowing by any
means. Sure it is not as bad as a radiator but everything
possible has been done to compartmentalize and baffle the engine.
The cylinders are each wrapped with alumnimun sheet with an
opening top and bottom, all the air has to flow up through those
slots. The air also has to make several abrupt turns. I would
guess that John's plenum with radiator, cooler and intercooler
has more open area than a plans built Cozy and a much freeer exit
path once past the coolers. Cozies are fraught with cooling
issues because the air really does not want to go where they are
putting it. The Long-EZ archives are full of schemes for trying
to improve cooling no matter what kind of scoop.
...Chrissi


Right, Chrissi. I think the Lycoming based Cozy cooling difficulties are
caused by the tortuous path the air has to travel. There HAS to be a lot of
back pressure and I doubt that all the available intake air is getting used.
I wish someone with a plans Cozy would do some of the manometer readings
Paul recommends. We'd all learn a lot.  Anyway, this is what made me think
(hope) that I can get away with cooling the 13B using the plans NACA. Note
that I don't have the intercooler in the plenum. There wasnt room. I have
two stock '93 oil coolers, one each side, and a large rad. I plan to duct
air from the rear sides of the plenum to the intercooler from one side and
the AC on the other. I'm half expecting to have to put some type of scoop in
to get enough air to the intercooler, but in the cause of experimentation, I
decided to take the opposite tack to Greg and start off with minimum scoops,
then work up. Note also that my "cowl flap" lets an adjustable amount of air
go straight out the back. This air should exit pretty much at the same speed
as it enters. In addition, I'm planning exhaust augmentation to help with
cooling on the ground.  You'll have to wait a while to see if this all
works.
John Slade
Cozy IV

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org