Marc Wiese wrote:
Now here is a picture of a cannon proof PSRU. It is the 3:1 drive that
Dave Garber is using and it comes from a Bell 47 helicopter rotor
gear box. Weighs only 43 pounds too. Dave paid about $300 for them
25 years ago. You can still get parts for Bell 47s in Trade A Plane.
I think this box would be good for about 1000 HP if anybody is
thinking
of building a 1000 HP turbo 3 rotor race motor.
Paul Lamar
Paul,
We need a kit for these for us 20B builders. How about Dave listing the
parts and specialty pieces and one of the machinists on the list getting
at it? How is the prop mounted to the reduction gear and where did the
housing come from?
[Marc Wiese]
Snip
Marc and all interested,
The rear counterweight in question is stock. What is special is that
the stock retaining nut for the counterweight has been replaced with a machined
combination retaining nut/adaptor for the Bell 47 planetary gearbox. As a point
of interest it looks like the entire rear housing is open to the planetary
housing lube system. Paul is that the way it is set up?
Kelly Troyer
Correct Kelly. Yes it is. Sorry about the mis-named jpg.
There is a drain to the pan and then on to the dry sump
system. The sheet metal oil dam keeps enough oil in the box to lube the gears.
With this box there is no limit to three rotor turbo power.
Anybody for a 3 rotor Nemesis Next outright Sportsman Class winner at Reno?
An TIO-550 ought to last about three seconds at the 900 HP level :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org