Subject: Custom 20 B oil cooler
From: ACRE NL
Date: 2/26/2002, 9:12 PM


Al Gietzen wrote:

Al Gietzen wrote:

Here are some pics of the custom oil cooler for my 20B built
by
Griffin.
It
is a very nice piece of work, and very heavy duty (also
heavy,
10
lbs) -
designed for 125 psi operating pressure.  The core is 20.5"
long, 5"
wide
and 3.34" thick.  Internal turbulators in the wide tubes
also
hold
them
together; they are brazed in.  14 fins/in.  Design point is
1600
cfm
air, 16
gpm oil, 220F oil in, 90F air in, resulting in heat
rejection of
2330
Btu/min.  Good for 220hp continuous on a hot day.


Looks beautiful Al!  If you don't mind my asking, how much did this
gem
set
you back?

Tom Kendall

One unit was $514.  2-10 units at $441 each.

Al


Nice looking oil cooler!!  Is the fitting on the upper right tank for a temp
gauge?  What size AN fittings are you going with?  Didn't see any mounting
tabs.

:Barny B

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org