Charlie and Tupper England wrote:
I need some info on repairing leaks in fiberglass fuel
tanks.I'm hoping for a non invasive procedure, something
like the metal tank guys do with low viscosity sealants
applied to the outside & a light vacuum applied to the tank
to pull sealant into the leak.
Have any of you 'glass airframe guys had any experience with
this?
If you can help, please email me offline at:
cengland@netdoor.com
Thanks,
Charlie England
I think that is of intense interest to all of us building composite
airplanes.
Pin hole leaks in composite airplane fuel tanks appears to be a very
common problem.
Paul Lamar
The tank sealant used on most "wet wing" metal planes is called Pro Seal
and
it adhears to fiberglass as well. This stuff is resistant to auto fuel
with
alcohol and works great but is not "sloshable". All of the sloshing
compounds (both aircraft and automotive) I've tried have failed the auto
fuel test. The small amount that I ran down the seams in my tanks
(thank
heavens I didn't actually slosh it) peeled off after about a year and
lodged
in the gascolator screen. BTW, this is one reason I like a coarse
filter
that can be inspected in the fuel system before the final fuel filter.
You
can see trouble coming before it becomes an in-flight emergency.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
Regarding the fuel leaks....On the first LongEZ I built, I had a similar
leak. I hooked up an altimiter to the fuel tank vent tube, and pulled
suction on the tank to 1500 feet of altitude, and let it set overnight. Of
course, it leaked. I then shot some freon into the tank, and quickly put
the fuel cap on, and checked with a freon leak detector. I found the
"approximate" area of leakage. I then mixed up some epoxy with a little
extra hardener so it would harden faster, then drew another vacuum and
brushed epoxy on the outside of the tank all around the suspect area.
Worked fine....never leaked again.
My opposite tank had too severe a leak for that. I took my hand held
jig saw, and set it at a 45 degree angle, and cut out a square approximately
6 inches in both dimensions, similar to cutting off the top of a pumpkin.
The hole must be large enough to get your hand and a paint brush into. I
applied fresh, thick epoxy thru the hole, then with an epoxy and flox
mixture, placed the top of the pumpkin back on, and put 2 plies of
fiberglass tape over the cut lines, sanded and faired, and it also never
leaked again. Hope this helps. Paul Conner, Mobile, AL
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org