Subject: Custom 20 B oil cooler
From: ACRE NL
Date: 2/27/2002, 8:20 PM


The inlet fitting on the right hand end is an AN10 (5/8").  The
small
fitting is a -4 (1/4), and is for an air bleed.  I will probably
reduce
that
to a 1/8 line back to the pan.  The outlet fitting is on the top of
the
left
hand tank and is a 3/4" NPT, which will accept the elbow transition
to AN12
which is under the cooler in the photo.

This cooler goes into the wing root on my Velocity.  A photo of the
cavity
is attached.  Air intake is at the bottom just behind the spar; exit
faring
on the top.  This gets finished out with a layer of fiberglass; the
cooler
slides in and is spaced off the glass with pads of KoolMat.  An
aluminum
plate supports the inside end and closes off the space.

Al

  I hate to sound like an idiot but what's KoolMat?

Mike Wills


It's a pricey fiberglass/silicone insulation material you can get from
Aircraft Spruce.  About 1/8 - 3/16 thick; withstands very high temps.  I
held a match to it and nothing happens.

Al

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org