Subject: Custom 20 B oil cooler
From: ACRE NL
Date: 2/27/2002, 12:02 PM


Nice looking oil cooler!!  Is the fitting on the upper right tank for a
temp
gauge?  What size AN fittings are you going with?  Didn't see any
mounting
tabs.

:Barny B

The inlet fitting on the right hand end is an AN10 (5/8").  The small
fitting is a -4 (1/4), and is for an air bleed.  I will probably reduce that
to a 1/8 line back to the pan.  The outlet fitting is on the top of the left
hand tank and is a 3/4" NPT, which will accept the elbow transition to AN12
which is under the cooler in the photo.

This cooler goes into the wing root on my Velocity.  A photo of the cavity
is attached.  Air intake is at the bottom just behind the spar; exit faring
on the top.  This gets finished out with a layer of fiberglass; the cooler
slides in and is spaced off the glass with pads of KoolMat.  An aluminum
plate supports the inside end and closes off the space.

Al

I really think you are going to have big problems with this installation
Al. I think the pressure will build up enough in front of the cooler
to divert the flow and thicken the boundary layer. We shall see.

Perhaps with a big enough inlet or outlet flap 18 inches long... but that 
will disturb a lot of air downstream under or over the wing.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Al-Gietzen-Oil_cooler.JPG

AG-OC_wing_root_cutout.JPG