Subject: Custom 20 B oil cooler
From: ACRE NL
Date: 2/27/2002, 3:51 PM


Nice looking oil cooler!!  Is the fitting on the upper right tank for a
temp
gauge?  What size AN fittings are you going with?  Didn't see any
mounting
tabs.

:Barny B


The inlet fitting on the right hand end is an AN10 (5/8").  The small
fitting is a -4 (1/4), and is for an air bleed.  I will probably reduce
that
to a 1/8 line back to the pan.  The outlet fitting is on the top of the
left
hand tank and is a 3/4" NPT, which will accept the elbow transition to AN12
which is under the cooler in the photo.

This cooler goes into the wing root on my Velocity.  A photo of the cavity
is attached.  Air intake is at the bottom just behind the spar; exit faring
on the top.  This gets finished out with a layer of fiberglass; the cooler
slides in and is spaced off the glass with pads of KoolMat.  An aluminum
plate supports the inside end and closes off the space.

Al

  I hate to sound like an idiot but what's KoolMat?

Mike Wills

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org