I really think you are going to have big problems with this
installation
Al. I think the pressure will build up enough in front of the cooler
to divert the flow and thicken the boundary layer. We shall see.
Perhaps with a big enough inlet or outlet flap 18 inches long... but
that
will disturb a lot of air downstream under or over the wing.
Paul Lamar
It's a tested idea. Other velocity builders have put their standard
aircraft coolers, that have higher pressure drops than mine, in this
configuration; and have had excellent results with NO scoop at the
inlet.
When you need the most air flow (climbing) there is significant pressure
difference between bottom and top of the wing. That's a good driving
force - don't know how much; but if it is more than the drop across the
core, it takes surprisingly little negative pressure to encourage the
air to
go into the inlet.
I do have a scoop at the bottom, but it is minimal for low drag. Based
on
the current evidence, I'm optimistic. And it is a low drag situation
using
the pressure difference between the wing surfaces rather than the
dynamic
pressure of a scoop.
But you're right - we shall see.
Al
Wing area 122 square foot and you were climbing out
at 100 MPH. Gross weight 2700 pounds 18 pounds per square foot average.
CL roughly is 0.70. Assuming the slot is at an average pressure
point. 0.125 psi.... 3.4 inches of water..... well perhaps.
That's the average pressure; but pressure varies significantly depending on
the location on the wing; highest (I think) about a third of the chord
length from the leading edge. Don't know what it is at the location of my
cooler.
The normal Velocity fuel cap location is in the strake just in front of the
spar. The fuel is gravity feed to a sump tank. There was a forced landing
of a plane due to fuel starvation because of a leakage in the fuel cap. The
tank was nearly full when this happened. The negative pressure above the
wing was enough to support about 10+" of fuel and keep it from flowing to
the sump. What is that - about 6" h20?
Interesting thing about this configuration is the pressure
difference across the wing appears to be constant with speed.
The average pressure remains the same, but the distribution shifts with
change in AOA. Based on tuft test results, I think the pressure will be
higher in the area of my cooler until the AOA get high enough to cause flow
separation toward the trailing edge.
It also appears to be a function of the gross weight at
a given speed. Lower weight less cooling. Interesting.
A conventional scoop would have this going for it;
Dynamic pressure is 26 pounds per square foot at 100 mph
or .18 psi or 4.86 inches of water but it gets much much better
at higher speeds. At a climb speed of 120 mph 37 pounds per square foot
.26 psi or 7 inches of water.
Maybe my oil cooler is going to be way too big :>)
Al
That would be nice for a change.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org