Subject: firewall tube jig
From: ACRE NL
Date: 3/4/2002, 3:54 PM


Paul,
In the enclosed picture, you have a square plate with some tube or
fitting
protruding. can you give more details on how this is fabricated? is
the motor
mount tube then just butt welded to the plate? If so,that doesn't seem
like
much weld strength, compared to a weld to a stub.

Bill Schertz
KIS Cruiser #4045

Yes they were butt welded than four small triangular gussets were used.
Make
the plates a bit bigger. I think these were two by two but something
like 2.5 by 2.5 would work better.

The welding jig shown turned out to be a disaster. I no longer recommend
it.

Here is a picture of Jerry's Hey's welding jig. Since he is building
a similar one for the Tail Wind. I think we can talk him into building
a jig for
the simple dual tripod mounts like you and I use on the Cruiser.

Paul Lamar


    To build engine mounts off of the airframe (as opposed to building
them in place) two things have to be possible.   First,  the hard points
on the firewall must be located AFTER receiving the engine mount.  The
engine mount is used as the pattern.  That way you get a perfect fit.
These should be very close to the design location but you can expect
some pulling from the welding.   Secondly, the same thing must be
possible at the opposite end where the PSRU adaptor joins the Barry
mount.  The socket that holds the Barry Mount to the engine mount tubing
will be in place and the PSRU adaptor trimmed to fit to it. ---  Jerry

In the case of a composite firewall the holes are drilled in the firewall
after the mount is made. The holes can move around on a composite firewall
plus or minus a couple of inches and not hurt anything.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org