Yes they were butt welded than four small triangular gussets were used. Make
the plates a bit bigger. I think these were two by two but something
like 2.5 by 2.5 would work better.
The welding jig shown turned out to be a disaster. I no longer recommend
it.
Here is a picture of Jerry's Hey's welding jig. Since he is building
a similar one for the Tail Wind. I think we can talk him into building a
jig
for
the simple dual tripod mounts like you and I use on the Cruiser.
Paul Lamar
-----------------------------------
In what way was it a disaster? Hard to get to the joints or movement?
Bill Schertz
KIS Cruiser #4045
Both. Mostly hard to get to the joints and too much work to build.
Easier to get a welding torch and learn to weld up a jig out of thick wall
square tubing as cosmetics have little to do with it. You can then let
a pro weld the final mount.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org