Subject: Outboard cooling - Two Stroke Engines (Was PSRU Questions)
From: ACRE NL
Date: 3/5/2002, 12:08 PM


Wrathall Mark wrote:

One point that didn't come up on the two-stroke outboard discussion this
time (I think we have discussed it before), was that fact that the water
jacket is designed for a high delta T (only using lake water once). Hard
to
belive you could run one of these things at rated power with a
recirculating
cooling system and no have localized boiling. Unless you have one hell
of a
large/efficient radiator.

Mark Wrathall


I flew my 135 hp OMC for around 150 hours.  Cooling was via 3 small heater
cores from Simca (the ugly little French car from the early 70s)  They are
just what I had laying around and were totally un-ducted (hanging out in the
breeze) so definitely not the last word in efficiency :)   Only mods to the
cooling jacket were to block the cooling passages from the exhaust cavity.
The cooling passages around cylinders & heads were very well optomized and I
had no problem with localized boiling.   This, in spite of the deflector top
pistons which made cooling a bigger task than with the excellent loop
charged 2 strokes available now.

Many assumed that the Mazda 13B water pump was optomized for low percentage
of power (like in car use) and would be inadequate for aircraft use.  I
think it has been proven to be quite adequate.   If the magic genie of mass
production lays a golden egg on your doorstep, don't reject it out of hand!

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org