Subject: Wanted to buy 12A rotor housings.
From: ACRE NL
Date: 3/5/2002, 2:26 PM


 > > Ken Welter wrote:
 > >
 > >   I am putting together a 4 port 13b for my coot and I thought I would
 > > show you this, I taper clearance my rotors by cutting .015 inch off
 > > at the tip and taper it off to zero at the bluing. This stops the
 > > tips from digging in to the side housings at high rpm and gives more
 > > room for expansion. I am building 4 port using 12a side housings and
 > > 85 13b GSE-LE rotor housings and after dismantling three 12a's I
 > > found they had very clean side housings as the narrower rotors expand
 > > less. Another advantage is the 84 and 85 rotor housings are thicker
 > > in the plug hole area as they made the later ones thinner for faster
 > > warm up time and better emissions. The o-ring grooves are in the
 > > aluminum housing so you do not have the problem of the cracked and
 > > rusted lips in the cast iron ones. 12a cores cheap and plentiful
 > > compared to 13b's and finding good side housings has been my biggest
 > > problem in core hunting.


 > I might add that Ken runs nitrous oxide through his engine on a regular
 > basis to get his 2900 pound Coot amphibian up on the step and out of the
 water.
 >
 > Paul Lamar


Richard Sohn wrote:

 Ken, are you willing to sell any of your good 12A rotor housings? I need at
 least 3 on the long run.

 Richard Sohn.
 unicorn@aic-fl.com


  I don't have any good housings. One 12a was in mint condition and I
put it together and flew it for 150 hrs.  I must say that the 12a
was very impressive, the other ones were junk.
  Ken Welter

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org