Subject: BOTH PP and side ports
From: ACRE NL
Date: 3/8/2002, 4:40 PM


The current output for 13B with two 38MM chokes is 225 HP at 9,300 RPM. That
is with as big a street port as you can grind. It wouldn't last long at that
speed. At 6000 RPM I don't know. The racers need power from 7,000 on up. 180
HP at 6000 sounds about right. I would leave the inserts in the exhaust
ports. Run 1 7/8" ID headers as long as possible before collecting. The exact
same length of both pipes is the most important feature. In GT-2 you can run
a bridge port and two 44MM chokes. Best power at 9,300 is just over 300HP. I
would build it with a mild street port, and if you don't like it you can add
the bridge port later on. If you are still unhappy you can go to the
periphery port later and just epoxy the side ports shut. You can assemble
part of the engine and copy the side port timing onto the rotor housing with
a marking pen and a small square. I used a piece of exhaust pipe formed into
a square on one end, and epoxied into place. I think this will be "air show"
power on a Tailwind.

Lynn E. Hanover
-----------------------------------------------------------------------------------------
Anyone ever thought about using BOTH PP and side ports at once? Is there anything that would prohibit this?
Brian Trubee

I think it is a good idea. Probably a new world record on HP per rotor
NA. What would really be even more interesting is both peripheral and side
exhaust ports.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org