Anyone ever thought about using BOTH PP and side ports at once? Is there
anything that would prohibit this?
> Brian Trubee
I think it is a good idea. Probably a new world record on HP per rotor
NA. What would really be even more interesting is both peripheral and side
exhaust ports.
Paul Lamar
Once I had discovered the magical qualities of Devcon Plastic steel I went
wild with the idea that "If a big port is good, a giant port must be great."
I built up a bridge ported engine and filled the rotor housing with Devcon to
keep the water out. There was just enough housing left in the center of the
port to keep the apex seal running flat. There was nearly the same area
missing from the housing as would be the case with a periphery port, plus
huge side ports. There was no difference in the lap times. It was a bit
harder to start was all. This was without increasing the choke size beyond
the legal 36MM or the intake runner size. So if port size was the limiting
factor in monster power I should have covered it back then. I think back now
and I should have carved up an intake manifold and matched the ports to it
and dropped in the big chokes just for one practice session just to be sure.
For airplane use, two 36MM chokes is damn small. And with injection there is
no choke at all. The big bridge port with the housing filled with epoxy is
very easy to do and with big runners without chokes it would have huge HP.
This is probable but the periphery port is for sure. You can't keep it from
working. You may not be able to cool it at full tilt but it will work.
Lynn E. Hanover
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org