Subject: BOTH PP and side ports
From: ACRE NL
Date: 3/8/2002, 9:26 PM


 > > Anyone ever thought about using BOTH PP and side ports at once?
Is
 there
 > > anything that would prohibit this?
 > >  > Brian Trubee


 > >  I think it is a good idea. Probably a new world record on HP per
 rotor
 > >  NA. What would really be even more interesting is both
peripheral
 and side
 > >  exhaust ports.
 > >
 > >  Paul Lamar


 > Once I had discovered the magical qualities of Devcon Plastic steel
I
 went
 > wild with the idea that "If a big port is good, a giant port must
be
 great."
 > I built up a bridge ported engine and filled the rotor housing with
 Devcon to
 > keep the water out. There was just enough housing left in the
center of
 the
 > port to keep the apex seal running flat. There was nearly the same
area
 > missing from the housing as would be the case with a periphery
port,
 plus
 > huge side ports. There was no difference in the lap times. It was a
bit
 > harder to start was all. This was without increasing the choke size
 beyond
 > the legal 36MM or the intake runner size.  So if port size was the
 limiting
 > factor in monster power I should have covered it back then. I think
 back now
 > and I should have carved up an intake manifold and matched the
ports to
 it
 > and dropped in the big chokes just for one practice session just to
be
 sure.
 > For airplane use, two 36MM chokes is damn small. And with injection
 there is
 > no choke at all. The big bridge port with the housing filled with
epoxy
 is
 > very easy to do and with big runners without chokes it would have
huge
 HP.
 > This is probable but the periphery port is for sure. You can't keep
it
 from
 > working. You may not be able to cool it at full tilt but it will
work.
 > Lynn E. Hanover


[Todd TC. Carrico]
I wonder if you could use the side ports at idle, and open up the PP at
full tilt boogie (this is a technical list is it not <g>).

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org