[Todd TC. Carrico]
I wonder if you could use the side ports at idle, and open up the PP
at
full tilt boogie (this is a technical list is it not <g>).
The peripheral ported engine is more docile than the bridge ported
engine.
They will both idle below 1,000 RPM but do not sound good doing it. It
will
be shaking the daylights out of the stationary gears and the gears in
the
PSRU. The race cars idle at 1,800 to 2,000 RPM. You can lean out the
idle mix
and slow them way down, but
we run every system full rich and then some to get enough fuel flow
above
9,000 RPM. Our Booster venturies are cut off at the bridge and we get
very
little secondary signal. I suspect that adjustable (Tracy's) fuel
injection
would allow any idle speed you would want no matter what ports you run.
Lynn E. Hanover
Idling an aircraft rotary engine at 2000 RPM is no problem. Don't
forget the
prop is turning only 922 RPM with a 2.17:1 gear box and only 682 RPM
with Ken Welters 2.93:1 belt reduction drive. Heck I idle my
O-470 at 1000 prop RPM to keep the plugs from fouling.
I have seen Tracy idle his engine at 1000 RPM with no gear box chatter.
That is because he uses rubber bushings to damp torque fluctuations
unlike the Ross spring clutch center.
Paul Lamar
I think Prop RPMs above 600 may present serious problems when you
trying to get down and running out of runway. Jerry
Not a problem for you Jerry as you are using Tracy's gear box.
This is mostly a problem for those using the old Ross gear boxes.
You should be slipping anyway. Or bring it in on the
back side of the power curve :-)>
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org