Subject: BOTH PP and side ports
From: ACRE NL
Date: 3/9/2002, 8:10 AM


[Todd TC. Carrico]
 > I wonder if you could use the side ports at idle, and open up the PP at
 > full tilt boogie (this is a technical list is it not <g>).


The peripheral ported engine is more docile than the bridge ported engine.
They will both idle below 1,000 RPM but do not sound good doing it. It will
be shaking the daylights out of the stationary gears and the gears in the
PSRU. The race cars idle at 1,800 to 2,000 RPM. You can lean out the idle mix
and slow them way down, but
we run every system full rich and then some to get enough fuel flow above
9,000 RPM. Our Booster venturies are cut off at the bridge and we get very
little secondary signal. I suspect that adjustable (Tracy's) fuel injection
would allow any idle speed you would want no matter what ports you run.
Lynn E. Hanover

Idling an aircraft rotary engine at 2000 RPM is no problem. Don't forget the
prop is turning only 922 RPM with a 2.17:1 gear box and only 682 RPM
with Ken Welters 2.93:1 belt reduction drive. Heck I idle my
O-470 at 1000 prop RPM to keep the plugs from fouling.

I have seen Tracy idle his engine at 1000 RPM with no gear box chatter.
That is because he uses rubber bushings to damp torque fluctuations unlike the
Ross spring clutch center.
 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org