Subject: BOTH PP and side ports
From: ACRE NL
Date: 3/10/2002, 9:07 PM


    This is a Factory periphery port housing sitting on top of a late
 > style
 >         housing with the "J" port (big bridge port that includes part of
the
 > rotor housing
 >         into the port) showing how the bridge ported engine has later
intake
 > closing
 >         than the periphery ported engine. Note that the "J" port extends
 > farther to the
 >        right in this picture. The later closing leads to poorer low
speed
and
 > idle
 >        performance. ( but great high speed performance).
 >        Lynn E. Hanover


 I assume you are using one piece apex seals with these bridge port engines
Lynn.


That is correct. I use .004" end clearance. The aluminum/carbon seals. I
tried the ceramic seals but saw no advantage, just alot more money.

Lynn E. Hanover

What is your estimate of the life of the carbon/aluminum in 150 HP continuous
use at about 5500 RPM?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org