Paul, it appears that the upper housing is the home made port?
 > I can still see the water  port on the outside of the housing.
 > It also appears that the exhaust port has been enlarged some as

well.

 > Royce

 Lynn??? Which is which?

    The lower housing is the stock factory housing.
    Lynn E. Hanover

Lynn,
Thanks for going to this trouble, it is greatly appreciated.
Questions
1. Is the housing (top one) naturally partitioned in this position of the PP
or have you shaped the partition with Devcon.
2. What is the hole in the outer cover - is that a guide hole ?
3. Does closing-off the water jacket (in this spot) cause any problems.
3. What is that plug shaped section on the RHS - it looks like a bolt hole
for something.
8.  How did Everett Hatch do his, it looks as though he tapped and drilled
four holes for each intake - my guess is that there is sufficient meat there
somewhere to do this ?

George (down under)

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org