Paul there is a discrepency between this drawing and the one which has
Tracy's  polar rendering  of the call outs for one  hole placement.
Looking at  the angles in the right hand column  the forth hole down,
on one drawing the input angle is 226-5-56 and on the other drawing  it
is 226-12-26.  Also the X/Y coordinates are different.   Jerry

Tracy Drawing is the final word. Best make a template and offer it up
to the end housings and see if it fits. Also when you come down
you can pick up Tracy's plate and copy it exactly like I did.

Here are a few more of Tracy's drawings.

BTW if you come this weekend come down on Friday night as you can stay
over
night in the hangar apartment and we can get an early start Sat morning
to go to Tom's and Chuck's. I like to fly over the desert in the early
morning before it gets so bumpy. Bring your head set. I got a new
4 place intercom. I got another idea. Perhaps Chuck could meet us at
Tom's? Would save a couple of hours on the 182.

Paul Lamar

Paul,  I would like to come down on Friday.    I cannot leave  until
about 1:30 pm.    I'm guessing at a five o'clock arrival at Santa Paula
airport.    If that sounds O.K. then here I come.

We are nearly ready to mill the test  motor mount plate.  Is the center
hole counter bore on the outer face?  According to Tracy's note it is.
However, on one view it is shown as a dotted line so we are not sure.

Jerry

What is the latest on that counter bore Tracy? I know you have made
some changes. If Jerry orders a PSRU now what would you send him in
the way of counter bores?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org