Vance Jaqua wrote:
George
For your belt drive from the single rotor, why
not use the Mazda clutch mechanism instead of
the jack shaft with the motorcycle "basket"
Per the sketch below you would use a lightened
flywheel (incorporating the counterweight), and
a regular RX-7 clutch assembly. A special bell housing
(an easy casting) carries an outboard bearing set
to take the belt tension loads. The shaft is
supported at the flywheel end by the usual pilot
bearing, The shaft could be reworked from a
transmission input shaft, or machined from scratch.
Recessing the toothed pully (like a front wheel drive
wheel) put all the tension side loads into the
bearing and almost no load into the pilot bearng.
Replicate the clutch lever provisions into the bell
housing, and use hydraulic atuation.
Have you contacted Paul yet? as you can see I am cc
a copy to him.
Vance
George, Vance - this looks like a great idea. Thought I would mention one thing in case
you hadn't thought of it yet. I think that in forward flight, a teetering head two-rotor
system will suffer a 2 per rev shake. Think this is caused by dissymetry of lift, and the
resultant flapping/feathering of the rotors. The blades will need to be allowed to
continually accelerate and decelerate, if not a minute amount. Even with this, they will
induce oscillating torque impulses on the rotor shaft. I would think you would want to
make sure the clutch can handle the torque oscillations without slipping. It's not clear
how much of the torque impulses the main belt will absorb, and how much will be passed on
to the clutch. I don't know how to estimate the magnitude of the impulses, but it probably
can be done.
Hope this makes sense,
Scott
P.S. - maybe bounce this idea off Martin Hollmann of Aircraft Designs, Inc.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org