Subject: April Road & Track RX8 article
From: ACRE NL
Date: 3/14/2002, 10:54 AM
To: Dennis Simanaitis

Not only does R&T have the RX8 on the cover and a nice article
about it but there is also a Cosmo article on page 78 with a little
history of Mazda's road racing successes.

However not one word on how the rotary works or why it is better
than a piston engine.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

How-wankel-works3.txt
How the Wankel Works copyright by Paul Lamar

The wankel rotary consists of a three sided rotor moving in a modified oval
chamber or rotor housing. There are at least two holes in the walls of one
side of the rotor housing. In the other side of the rotor housing there is
at least one spark plug. One hole is used as an intake port and the other as
an exhaust port. Just like a one cylinder two cycle piston engine. The rotor
rotates around the center of the eccentric on the output shaft while at the
same time rotating around its own axis. This is very similar to the way the
earth rotates around the sun while rotating around its own axis. The rotor
rotates one third as fast about its own axis as it does around the center of
the output shaft. Actually what is happening is the center or CG of the
rotor is moving in a circle around the center of the output shaft while the
output shaft rotates. Very very clever on the part of Felix Wankel to invent
and engine that uses this motion.

Many engineers and mechanics that should know better still think the rotor
translates, reciprocates or wobbles in the rotor housing. Nothing could be
further from the truth. The key is to think only of the center of the rotor.
That is the center of gravity of the rotor and what that does is all that
counts. It rotates around the center of the eccentric shaft pure and simple.

As this motion is taking place the tips of the triangular shaped  rotor are
passing the ports in the housing. As one tip, call it tip 1, passes the
intake port in the rotor housing the face behind tip 1 starts to draw in the
fuel air mixture. Call it face or chamber A.  When the next tip call it tip
2 passes the intake port the mixture is captured and starts to compress. As
the chamber continues around the housing it encounters the spark plug and
the mixture inside it is fully compressed.  The spark plug fires and the
chamber starts to expand imparting the pressure energy in the burning
mixture to the output shaft. As the rotor continues on around tip 1 passes
the exhaust port and the burnt mixture starts to leave chamber A. This
completes the four cycles for chamber A. In the mean time chamber B and
chamber C are completing various cycles of this same sequence
simultaneously.

This three chamber simultaneous action  is the reason the wankel  engine is
so light and compact for the power it is able to generate. Furthermore the
forces in each chamber due to the pressure in each chamber are completely
contained in the one piece cast iron rotor. In a four cycle piston engine
this is not the case. The compression force must pass down a connecting rod,
into the crankshaft and up another connecting rod into another chamber that
is expanding and extracting power from the burning mixture. This makes
piston engine force paths and consequent stresses far far more complicated
than the wankel engine.

Although the wankle has similarities with a two cycle engine,  particularly
in regard with the way the porting mechanism works, it is in no way a two
cycle engine. All four cycles are continuously taking place simultaneously
and those are intake, compression expansion and exhaust.
 
Paul Lamar
 
The AirCraft Rotary Engine News Letter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org