Subject: Twin rotor motor tranny? PT6 reducers?
From: ACRE NL
Date: 3/14/2002, 9:52 PM


 > >  > Here is an interesting subject that I have not seen discussed in
my
 years on this list.
 Has anyone tried to duplicate the overriding clutch or whatever
it
 is/was on the "twin pack" rotary set up done by that European
outfit
 several years ago? Can't remember the name (Swiss company?), I
think
 they are out of business. Anyhow, it seems a very elegant
solution
to a
 high hp redundant twin, esp for helicopters or even a large
cabin
class
 craft.
 How did that tranny work? The engines were side by side.

 BTW, any word on those PT6 gear drives?
 [Marc Wiese]

   From Ken Welter
  Yes I have here is a photo of my twin pack that will go on the 4
place coot that I am starting to build, I installed this pack on my
present coot and tested it for 11 hrs and was a bit heavy for it but
should work on the bigger one, the front engine is a 670 Rotax
snowmobile engine that puts out 125 hp but there is no reason that
it
should not work with two rotary's however part of the design to stop
resonant vibration is to run two very different rpm's so you would
run two different gear ratios and I would suggest running a 12a and
a
13b, the sprag clutches that I used were made by SSK and sold by
Morse.


That is one neat set up. Wow. But it isn't the one I had in mind. Yours
is end to end straight thru to the prop. The other set up had the 2
engines side by side and a gear set on the front that straddled the 2
engine in a housing. It was made to emulate the config of a horizontally
opposed type aircraft engine under the cowl.
[Marc Wiese]

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org