Ed Anderson wrote:
The older I get - the more I find out I don't know, its getting
scary
{:>)
I never gave it any thought until I went looking for a local
distributor
of
bulk 2 cycle oil. Naturally I used the Internet and did a search and
found
some very interesting information. Many of you may know this
already,
but I
did not know there was two cycle oil differently formulated depending
on
whether it is designed to be used in a air cooled or water cooled 2
cycle
engine. Here is what a brief extract of the article said. The
opposite
of
what I would have thought - had I thought about it.
"Water-cooled two-cycle engine oils require higher levels of a heavy
oil
to
prevent piston and cylinder wall scuffing. Because of their high
average
piston temperature, lighter oils evaporate too quickly from the
piston
cylinder contact area. The heavy base oil, which vaporizes at very
high
temperatures, resists evaporation and remains in place to provide
lubrication to the piston and cylinder. Air-cooled oil formulations
must
have much lower levels of the heavy base oil than water-cooled engine
oils.
These oils require only a small amount of heavy oil to provide
protection
against piston scuffing and seizure at peak temperatures. Heavy
levels of
heavy base oils in an oil formulated for air-cooled engines can cause
engines deposits"
More info at this URL
http://www.ultralightnews.com/features/oilworks.htm
Don't know if it really matters or whether the rotary engine
combustion
chamber heat characteristics would be more like the water cooled or
air
cooled piston engine. FWIW
Ed Anderson
Matthews, NC
RV-6A N494BW
eanderson@carolina.rr.com
Ed,
Probably because the water cooled engines have tighter tolerances.
George (down under)
Good Point, George
I presume as long as the 2 cycle oil meets the required specification it
will be OK. However, I have noticed a considerable difference in the price
of 2 cycle oil which makes you wonder what you are getting additonal for the
higher priced stuff. For example a gallon (U.S) of Pennzoil Marine
Synthetic is USD $18.57 a gallon. AMZOIL on the other hand for their ATC-01
2 cycle oil is $30.60 a gallon. Sure makes you wonder what the real
difference is.
Ed Anderson
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org