> > From Ken Welter
> > Yes I have here is a photo of my twin pack that will go on the 4
> > place coot that I am starting to build, I installed this pack on my
> > present coot and tested it for 11 hrs and was a bit heavy for it but
> > should work on the bigger one, the front engine is a 670 Rotax
> > snowmobile engine that puts out 125 hp but there is no reason that
it
> > should not work with two rotary's however part of the design to stop
> > resonant vibration is to run two very different rpm's so you would
> > run two different gear ratios and I would suggest running a 12a and
a
> > 13b, the sprag clutches that I used were made by SSK and sold by
Morse.
> >
That is one neat set up. Wow. But it isn't the one I had in mind. Yours
is end to end straight thru to the prop. The other set up had the 2
engines side by side and a gear set on the front that straddled the 2
engine in a housing. It was made to emulate the config of a horizontally
opposed type aircraft engine under the cowl.
[Marc Wiese]
From Ken Welter
The problem with the side by side is the two engines have to be
solidly connected together and you get the resonant vibrations acting
together.
A lot of hotrodders have and sometimes still do, connect two engines together
crankshaft to crankshaft. Wonder how they deal with harmonics?
Royce
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org